3D Systems CubePro 3D Printer User Manual page 74

NOTE: The print material will begin to back out of the extruder.
4. Once the print material has been extracted from the extruder, cut off the end of the print material. Select the
5. Remove the cartridge from the printer. Select the
6. Insert the cleaning filament into the extruder. Select the
NOTE: The metal clamp stops the end of the material from continuing into the
extruder. You should not reach this point while cleaning the extruder.
7. When prompted, pull out the cleaning filament from the extruder. Select the
checkmark to continue.
checkmark to continue.
checkmark
checkmark
to continue.
to continue.