3D Systems CubePro 3D Printer User Manual page 29

Up to 28.54cm(w) x 27.04cm(d) x 23cm(h)

Table of Contents

Apply two (2) thin layers of glue to the center of the plate. Select the

checkmark

to continue.

NOTE: For more information, refer to the section titled

Applying Cube

Glue.

NOTE: For small print ﬁle sizes, use a light coating of glue. For larger parts, a slightly

thicker coating of glue is recommended. When the printer begins to print, the glue

surface should be mostly dry. The temperature from the print material will melt the

surface of the glue increasing its adhesion.

NOTE: Ensure that the area where glue is applied is larger than the base of your

creation.

NOTE: The estimated time to completion is noted at the bottom of the screen.

NOTE: When printing with ABS material, the print chamber will need to build and

maintain a predetermined temperature. Ensure the top cover and the back panel have

been installed. The front door must be closed.

NOTE: When printing with PLA only or both PLA and ABS material, the print chamber

will not need to be preheated.

NOTE: The print jets required for the print job will begin to heat.

CAUTION: Do not touch the print jets until they have cooled to room temperature.

Table of Contents

Show Quick Links

Table of Contents

Need help?

Do you have a question about the CubePro 3D Printer and is the answer not in the manual?