Operation Procedures; Applying Cube Glue - 3D Systems CubePro 3D Printer User Manual

Up to 28.54cm(w) x 27.04cm(d) x 23cm(h)

Table of Contents

OPERATION PROCEDURES

Cube Glue contains water-soluble glue that adheres the part to the print pad. It is important that glue is

applied to the print pad before starting any print to ensure that the creation does not move during the

printing process.

The glue contains a foam applicator under the cap. It is recommended that the bottle is turned upside-

down with the cap on to allow the glue to settle into the applicator before applying.

For best results, apply two thin layers of glue to the print pad using slow circular motions when prompted

by the touchscreen display. Apply the glue in a pattern that is slightly larger than the footprint of the

creation you are printing.

Layer 1

Apply a thin layer of glue to the print pad:

Layer 2

Apply a second thin layer of glue to the print pad in the opposite direction:

NOTE: For best results, allow the glue to dry before printing.

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the CubePro 3D Printer and is the answer not in the manual?