3D Systems CubePro 3D Printer User Manual page 21

Up to 28.54cm(w) x 27.04cm(d) x 23cm(h)

Table of Contents

To continue with the test print, select PRINT.

NOTE: If the test print ﬁle uses a color that is not installed in the printer, select the

checkmark to enable the printer to change the color of the print to a color currently

installed.

19.

Apply two thin layers of Cube Glue to the print pad. Select the

NOTE: For more information, refer to the section titled

NOTE: Apply enough glue to cover a square area of 5"/15 cm in the center of the print

pad.

NOTE: For best results, ensure the glue is dry prior to printing.

NOTE: Print jet 1 will begin to heat.

checkmark

to continue.

Applying Cube

Glue.

Table of Contents

Show Quick Links

Table of Contents

Need help?

Do you have a question about the CubePro 3D Printer and is the answer not in the manual?