Printing Your Creation; Printing Procedure - 3D Systems CubePro 3D Printer User Manual

PRINTING YOUR CREATION

There are many 3D creations available at 3dsystems.com/shop/cubepro/downloads. For more information
about converting a .stl file into a .cubepro file which the printer can use, refer to the section titled
Software.

Printing Procedure

The following steps illustrate how to print a creation.
1. After powering up your printer and turning on your display, press the touchscreen to begin.
2. Select PRINT.
NOTE: If the file is saved on a USB mass storage device, insert the device into the USB
port on the printer.
NOTE: You can also print directly from the CubePro software using a wireless
connection.
3. Using the arrows, navigate to your file and select PRINT.
NOTE: The file name will be displayed at the top.
NOTE: If the print file requires PLA material and ABS material is installed, the printer
will prompt you to change the cartridge(s). Select
the section titled Replacing A Material
CHANGE CARTRIDGE
Cartridge.
CubePro
and refer to