Error Codes - 3D Systems CubePro 3D Printer User Manual

ERROR CODES

Material Flow Errors
Material flow errors that appear on the display contain two (2) digits. The first digit refers to the extruder
number. (Ex. If your printer has two (2) extruders and you have code 13, the error refers to extruder 1.)
The second character refers to the error type. Refer to the following chart for descriptions of material flow
error types:
Error
Description
Type
1 Material stopped
2 Idler stalled
3 Material not present
Temperature Errors
Temperature errors that appear on the display contain two (2) digits. The first digit refers to the extruder
number. (Ex. If you printer has three (3) extruders and you have code 35, the error refers to extruder 3.)
The second digit refers to the error type. Refer to the following chart for descriptions of temperature error
types:
Error
Description
Type
1 Thermistor circuit
2 Initial rate of change low
3 High rate of temperature change detected
4 Low rate of temperature change detected
5 Set point deviation
For more information, contact Cubify Support.
CONTACTING SUPPORT
Cubify Support is available at cubifysupport@cubify.com.
Possible Cause
• Tangled cartridge
• Extruder blockage
• Tangled cartridge
• Extruder blockage
• The end of the material has been pulled into the extruder
Possible Cause
• Possible short circuit detected
• Contact support
• A sudden change in temperature was detected
• The rate of temperature increase is below the expected rate of change
• The temperature is different from the target temperature