Table of Contents
Advertisement
REPLACING FUSES
The printer has two (2) fuses that are designed to provide moderate circuit protection. If the fuses become
defective, refer to the following procedure to replace the fuses.
Caution: Double Pole/Neutral Fusing.
1.
Power off the printer and disconnect the power cord from the printer.
2.
Open the fuse door above the main power switch.
3.
Remove the fuse cartridge from the power inlet housing.
4.
Remove the defective fuses and install new ones.
Caution: Ensure the replacement fuses are rated correctly.
NOTE: Fuse: 5x20mm T10A L 250V.
5.
Insert the fuse cartridge into the power inlet housing.
6.
Close the fuse door.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the CubePro 3D Printer and is the answer not in the manual?
Questions and answers