Noise Level; Data Reg. The Electrical And Hydraulic Equipment - Meiko DV 80.2 Operating Instructions Manual

Operating instructions DV 80.2 / DV 120.2 / DV 125.2 / DV 200.2 / DV 200.2 PW
12.1.6 Detergent dosage
The detergent dosing unit (option) is designed for the automatic adding of liquid, alkaline
detergent into the wash water.
The detergent is transported out of the container into the wash tank by means of a hose
line. The dosing unit is self-priming. The dosing is effected during each filling cycle and at
the beginning of each programme cycle using timer control.
Normally, a dosing of approx. 2 ml of detergent per liter of tank water is the correct
concentration. This can be increased/reduced acc. to the water quality, items to be
washed and degree of soiling to 5 ml/l or to1 ml/l.
12.1.7 Rinse aid dosing
The rinse aid dosing unit is designed to automatically add liquid final rinse aid into the fresh
water.
The rinse aid is transported out of the container into the fresh water supply line by means of
a hose line. The dosing unit is self-priming. The dosing takes place during each filling
cycle.
The correct dosing results in a smooth, even water film.
In case of overdosing, there are bubble and stripe formations - reduce dosing.
In case of under-dosing, water drops remain on the washed items - increase dosing.
12.1.8 Airbox AktivAir
After the wash is finished the extraction fan is switched on for three minutes. The time can
be set using a time relay. Times shorter than three minutes should not be set because
otherwise residual moisture would stay in the housing and possibly damage the fan motor

12.2 Noise level

Work place noise level LpA £ 70 dB

12.3 Data reg. the electrical and hydraulic equipment

See attached technical sheet
Datei:BA_DV80.2_120.2_125.2_200.2_200.2PW_9625769_EN_2002-10.doc
MEIKO Maschinenbau GmbH & Co. KG, Englerstr. 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
12.1.5 Water change programme (option)
The program pre-selection keys can be allocated to a water change programme. In the
standard setting this applies only to button III.
After completing the wash programme, all the water is pumped out of the the tank.
Flushing with fresh water follows. This water remains in the wash tank and is used as the
next tank filling.
Then the programme ends and the programme start button light goes out.
Now the following options are possible:
1. Open door, remove tray, close door; this makes the washer ready for operation (fill
tank, heat)
2. Switch to programme 1 or 2; this makes the washer ready for operation (fill tank, heat)
3. After changing the tray, press the start button; this makes the washer ready for
operation (fill tank, heat), and then immediately starts the washing programme.
4. Press the "0" button (off button) and then press the start button to launch the self-
cleaning programme for complete flushing of the machine.
W e reserv e the right to change execution and construction!
9625769 23/46