I 2 Of 5 Maximum Label Length - Datalogic Magellan 8500 Product Reference Manual

I 2 of 5 Maximum Label Length

NOTE
Product Reference Guide
This feature specifies the maximum allowable length of an I 2 of 5 label.
Length in this case includes check and data characters, but does not
include start or stop characters. This feature applies when I 2 of 5
Length Control is set to variable-length decoding.
Maximum label length should be greater than or equal to minimum label
length.
To set this feature:
1. Scan the SWITCH barcode.
2. Scan the barcode, SET I 2 OF 5 MAXIMUM LABEL LENGTH
below. You'll need to cover any unused barcodes on this and the
facing page to ensure that the scanner reads only the barcode you
intend to scan.
3. Scan the appropriate digits from the keypad in
represent the desired maximum label length. The selectable range
for this option is 02 to 50, even numbers only. Pad all single digit
numbers with a leading zero to yield a two-digit entry (02-50).
4. Complete the programming sequence by scanning the SWITCH
barcode.
SET I 2 OF 5 MAXIMUM LABEL LENGTH
that
Appendix C
6-225