Single Cable RS-232 Use ACK/NAK
6-112
Enables/disables the ability of the scanner to use ACK/NAK.
To set this feature:
1. Scan the SWITCH barcode.
2. Scan either the enable or disable barcode below. You'll need to
cover any unused barcodes on this and the facing page to ensure
that the scanner reads only the barcode you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
barcode.
SINGLE CABLE RS-232 USE ACK/NAK = DISABLE
SINGLE CABLE RS-232 USE ACK/NAK = ENABLE
Magellan
8500 Scanner
®