Gtin 2-Digit Supplemental Label Id - Datalogic Magellan 8500 Product Reference Manual

GTIN 2-Digit Supplemental Label ID

The programming feature, RS-232 Label ID Control, designates whether
the Label ID is transmitted as a prefix or suffix or if Label ID is disabled.
NOTE
Product Reference Guide
This feature specifies a GTIN label ID to be added to barcode data when
GTIN conversion is enabled and 2-digit supplemental addon barcode
labels are converted.
To set this feature:
1. Scan the SWITCH barcode.
2. Scan the barcode, SET GTIN 2-DIGIT SUPPLEMENTAL LABEL
ID below. You'll need to cover any unused barcodes on this and the
facing page to ensure the scanner reads only the barcode you intend
to scan.
3. Scan the appropriate digits from the keypad in
resent the desired Label ID characters; entered as two hex pairs. A
table containing the ASCII Character Set and their corresponding
Hex Values is available in the inside back cover of this manual.
ASCII parameters must be input by scanning a pair of hexadecimal
digits for each character. Thus, to set a two-character value of AB,
barcodes containing the digits '4', '1', '4', and '2' must be scanned.
The selectable range for this option is any hex value from 00 to FF
(for each of the two characters).
4. Complete the programming sequence by scanning the SWITCH
barcode.
SET GTIN 2-DIGIT SUPPLEMENTAL LABEL ID
that rep-
Appendix C
6-169