Motor Timeout - Datalogic Magellan 8500 Product Reference Manual

Motor Timeout

Laser safety requires that the laser switch off before the motor. If you set the
motor timeout shorter than the laser timeout, the motor and the laser will
both shut off when the motor timeout expires.
NOTE
Product Reference Guide
The Motor Timeout feature sets the time for automatically switching the
motor off when the scanner is not in use.
To set the Motor Timeout:
1. Scan the SWITCH barcode.
2. Scan your selection from the barcodes below. You'll need to cover
any unused barcodes on this and the facing page to ensure that
the scanner reads only the barcode you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
barcode.
MOTOR TIMEOUT = 5 MINUTES
6-15