Gtin 2-Digit Supplemental Label Id - Datalogic MAGELLAN 8300 Product Reference Manual

GTIN 2-Digit Supplemental Label ID

The programming feature, Label ID Control, designates whether the Label ID
is transmitted as a prefix or suffix or if Label ID is disabled.
NOTE
Product Reference Guide
This feature specifies a GTIN label ID to be added to bar code data when
GTIN conversion is enabled and 2-digit supplemental addon bar code
labels are converted.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan the bar code,
below. You'll need to cover any unused bar codes on this and the
ID
facing page to ensure the scanner reads only the bar code you intend
to scan.
3. Scan the appropriate digits from the keypad in
represent the desired Label ID characters; entered as two hex pairs.
A table containing the
ing Hex Values is available in the inside back cover of this manual.
ASCII parameters must be input by scanning a pair of hexadecimal
digits for each character. Thus, to set a two-character value of AB,
bar codes containing the digits '4', '1', '4', and '2' must be scanned.
The selectable range for this option is any hex value from 00 to FF
(for each of the two characters).
4. Complete the programming sequence by scanning the SWITCH
bar code.
SET GTIN 2-DIGIT SUPPLEMENTAL LABEL ID
SET GTIN 2-DIGIT SUPPLEMENTAL LABEL
ASCII Character Set
GTIN Enable
that
Appendix C
and their correspond-
6-259