Configure Service Zone Network - LevelOne WHG-311 User Manual

5.6.2. Configure Service Zone Network

Configure Service Zone; go to: System >> Service Zones >> Service Zone Configuration.

Service Zone Status: Each service zone can be enabled or disabled except for the default service zone.

Service Zone Name: The name of service zone could be input here.

Network Interface:
VLAN Tag (Tag Base Only): The VLAN tag number that is mapped to the Service Zone.
o
Inter LAN Port Isolation (Port Base Only): Select Enable, Auth Required or Disable. When the
o
option is "Enabled", clients under different LAN ports cannot ping each other. When the option is
"Disabled", clients under different LAN ports can ping each other. When the option is "Auth
Required", clients under different LAN ports cannot ping each other unless both of them has
successfully authenticated.
Operation Mode: Contains NAT mode and Router mode. When NAT mode is chosen, service zone
o
runs in NAT mode. When Router mode is chosen this service zone runs in Router mode.
IP Address: The IP Address of this service zone.
o
Subnet Mask: The subnet Mask of this service zone.
o
Router Mode
NAT Mode
47