Table of Contents
Advertisement
4. Getting Started
4.1.
Accessing Web Management Interface
When you have completed the hardware installation of your WHG Controller, system configurations can be
performed via built-in Web Management Interface (WMI).
Step 1. Connect your PC to any of the LAN ports of your WHG Controller.
Step 2. Set the TCP/IP settings on your PC to "Obtain an IP address automatically".
Step 3. Launch a web browser and enter the WHG Controller's default LAN IP address "192.168.1.254". If you are
connected to a Mgmt port (WHG-401, WHG-505, WHG-515) please enter the mgmt port IP address "172.30.0.1".
Step4. Enter the default administrator account and password "admin" to login. Once logged into the WMI, the
system's Home Page will be displayed.
If your PC is connecting to the LAN port, and you can't get the Administrator's login screen, the reasons may be:
(1) The PC is set incorrectly so that the PC can't obtain the IP address automatically from the built-in DHCP Server;
(2) The IP address and the default gateway are not under the same network segment.
Please use default IP address such as 192.168.1.xx in your network and then try again.
29
Advertisement
Table of Contents
