Dynamic Route - LevelOne WHG-311 User Manual

11.7. Dynamic Route

Configure Dynamic Route; go to: Network >> Dynamic Route.
The function supports three dynamic routing protocols: RIP, OSPF and IS-IS.

RIP Configuration: It is a dynamic routing protocol used in local and wide area networks. You can configure
each interface to be Passive, supportive version and authentication.

Passive: RIP packets will not be sent from network interfaces that are checked as Passive.

Version: Select the RIP version for this interface, RIPv1 uses broadcast to deliver RIP packets, RIPv2
uses Multicast to deliver RIP packets, both uses broadcast and multicast.

AUTH: AUTH: Allows the authenticating of RIP neighbors. The authentication method "none" means that
no authentication is used for RIP and it is the default method. The two modes of authentication on an
interface for which RIP authentication is enabled: plain text authentication and MD5 authentication.

Advertise I am Default Gateway: Inform neighboring nodes that this controller is the default gateway.

Advertise Global Policy Route: Inform neighboring nodes the Global Policy route on this controller.

Redistribute OSPF: Check this option to enable using RIP to distribute routing information acquired via
OSPF.

RIP Timer:
 Update timer: Specify the time in seconds when the system will request for immediate update in
176