Seamless Cross Gateway Roaming - LevelOne WHG-311 User Manual

17.4. Seamless Cross Gateway Roaming

Configure Notification; go to: Network >> Client Mobility >> Cross Gateway Roaming.
WHG Controllers supports seamless inter-Controller roaming with up to 15 other Controllers in a star like topology.
The Master Node means that this Controller will be at the center of the roaming cluster, and its users can roan with
all the Slave nodes.
The Slave Node are Controllers that are connected to the Master node (Master AP), their users can only roam with
the Master node.
Master Node
Master node can roam with many slave nodes. Contains 15 entries where network administrator can specify the
slave nodes that will perform roaming with this master node. Fill in the IP address and common secret key. Check
the "Active" check box and apply to enable roaming tunnel between the master node and slave node.
Slave Node
Slave node can only roam with the master node. Fill in master node's IP address and common shared secret to
establish roaming tunnel between the master node and slave node.
267