Table of Contents
Advertisement
2.2.
WHG Controller Hardware Overview
2.2.1. WHG-311 Hardware
1
1
Quick Buttons
2
LED Displays
3
WAN1/ WAN2
4
LAN1~ LAN8
5
SD Disk
6
USB
7
Console
2
3
Reset: Press and hold the Reset button for over 3 seconds and status of
LED on front panel will start to blink, release button at this stage to
restarting the system. Press and hold the Reset button for more than 10
seconds and status of LED on the front panel will turn from blinking to off,
release at this stage to reset the system to default configuration.
Quick-Restore: This button is the firmware switch button. Press this
button while system is powering up and release when the "Quick-Restore"
LED lights up, the system will switch to the other firmware image and boot
up with that firmware.
Quick-VPN: Function reserved for future release.
Quick-Offload: Function reserved for future release.
Power: Power LED lights up as constant green when power supply is on.
Status: Status LED is Blue. Blinking indicates that system OS is booting
up, when lit up constantly indicates that the system is ready for operation.
Quick-Restore: This is used to indicate that the system will now switch to
the other F/W partition for operation.
Quick-VPN: Function reserved for future release.
Quick-Offload: Function reserved for future release.
Two Gigabit WAN ports (10/100/1000 Base-T RJ-45) for uplink connections to
the external network, such as the ADSL Router from your ISP (Internet Service
Provider).
Eight Gigabit LAN ports for servicing LAN traffic (10/100/1000 Base-T RJ-45).
Used for system storage, please do not remove during operation.
Function Reserved for future use.
The system can be configured via a serial console port. The administrator can
use a terminal emulation program such as Microsoft's Hyper Terminal to login to
the configuration console interface to change admin password or monitor system
status, etc.
4
5
10
6
7
Advertisement
Table of Contents
