Manually Add Ap - LevelOne WHG-311 User Manual

9.4.

Manually add AP

Add an AP Manually; go to: Access Points >> Enter Local Area AP Management >> Adding.
The administrator can add supported APs into the List table manually here. Similar to the AP added after discovery,
a manually added AP will show up with a status of "configuring" in the AP List initially. The system will attempt to
configure the AP with the value specified. A couple of minutes later, the AP's status will become "online" or "offline"
on the AP List.
The AP can also be added manually without being online. Input the related data of the AP and select a Template.
After clicking Add, the AP will be added to the managed list.

AP Type: The model type of the AP for adding to the List.

AP Name: Mnemonic name of the specific AP.

Admin Password: Password required for this AP.

IP Address: IP address of the specified AP.

MAC Address: MAC address of the specific AP.

Remark: Some extra information to be filled in for this AP if desired.

Service Zone (Tag-Based only): This item is only shown when Tag-Based mode is selected in System
Configuration >> LAN Port Mapping. Select the name of Service Zone such as Default, SZ7, etc. And it is
only for Multi-VAP AP only.

Template Applied: The template which will be applied to the added AP.

Channel: The selected channel will be applied to the added AP.
134