Ap Operations From Ap List - LevelOne WHG-311 User Manual

10.6. AP Operations from AP List

Perform operations on managed APs; go to: Access Points >> Enter Wide Area AP Management >> List.
After adding APs to the managed List, the List page provides some operations for managing the listed AP's.

Goto: The WHG Controller cannot directly configure Wide Area AP's settings remotely. However, the
Goto button is a convenient link for accessing the remote AP's WMI.
Please note that the Goto button will only become active when the listed AP's status is Online.
The drop down list on the column header is for specifying which WMI page to go to.

Edit (AP Attribute): Click this button to enter the AP's attribute editing page where administrator can
specify the Device Name and SNMP community. If the AP is to be marked on a map, this page also
allows administrator to configure the geographical location, coverage, related links and customize marker
or icon images that will be displayed on the map.

Edit (Tunnel Status): Only applicable to EAP-200 APs. Click this button to setup a secure tunnel
between the WHG Controller and the listed EAP-200. Once the tunnel has been established, the AP can
be seen as logically connected under the WHG Controllers managed network and can be applied a
Service Zone.

Delete: Remove the checked AP from the List.

Add to Map: Clicking this button will open a popup window. Administrator can Mark the selected APs on
the Map chosen from the drop down list. If no map profile has been configured, there will be no available
map to choose in the drop down list.

Backup Config: Clicking this button will open a popup window where administrator can backup the
chosen AP's configuration settings into a .db file store in the WHG Controller's memory. The Backup up
files are listed under Backup Config tab page for download or deletion.

Restore Config: Clicking this button will open a popup window where administrator can restore the
164