Table of Contents
Advertisement
2.2.4. WHG-505 Hardware
2
1
1
LED Indicators
2
LCD Display
3
Console
4
Reset
5
USB
6
Mgmt
7
WAN1/ WAN2
8
LAN1/ LAN2
1
Power Supply Socket
2
Power Switch
3
Device Cooling Fan
3
4
5
6
There are three kinds of LED, Power, Status and Hard-disk, to indicate
different status of the system.
Allows network administrator to check important system settings such as
network interface, SZ configurations, etc. The navigations buttons from left to
right respectively are "Esc", "Up", "Down", and "Enter".
The system can be configured via a serial console port. The administrator can
use a terminal emulation program such as Microsoft's Hyper Terminal to login to
the configuration console interface to change admin password or monitor
system status, etc.
Press and hold the Reset button for about 5 seconds and status of LED on front
panel will start to blink before restarting the system.
Press and hold the Reset button for more than 10 seconds and status of LED
on the front panel will start to speed up blinking before resetting the system to
default configuration.
Reserved for future use.
For management use only, it always will open WMI (Web Management
Interface) homepage.
Two Gigabit WAN ports (10/100/1000 Base-T RJ-45) for uplink connections to
the external network, such as the ADSL Router from your ISP (Internet Service
Provider).
Two Gigabit LAN ports for servicing LAN traffic (10/100/1000 Base-T RJ-45).
Connecting the power cord to the built-in open-frame power supply (Input:
100~240 VAC, 50/60 Hz).
Power-On () & Power-Off ( O ).
Don't block the cooling fans. Leave enough open space for ventilation.
13
7
8
Advertisement
Table of Contents
