Table of Contents
Advertisement
2.2.6. WHG-707 Hardware
1
1
WAN1/ WAN2 (SFP)
2
LAN5/ LAN6 (SFP)
3
LED Indicators
4
WAN1/ WAN2
5
LAN1 ~ LAN4
6
USB
7
Console
8
LED Indicators
9
LCD Display
1
Power Supply Socket
2
Power Switch
3
Device Cooling Fan
2
3
4
Two combo WAN ports (SFP) are connected to the external network, such as
the ADSL Router from your ISP (Internet Service Provider).
Client machines connect to WHG Controller via these LAN ports (SFP).
There are four kinds of LED, WAN1, WAN2, LAN4, and LAN5, to indicate the
traffic status of the SFP ports.
Two WAN ports (10/100/1000 Base-T RJ-45) are connected to the external
network, such as the ADSL Router from your ISP (Internet Service Provider).
Client machines connect to WHG Controller via these LAN ports
(10/100/1000 Base-T RJ-45).
Reserved for future use.
The system can be configured via a serial console port. The administrator can
use a terminal emulation program such as Microsoft's Hyper Terminal to login
to the configuration console interface to change admin password or monitor
system status, etc.
There are three kinds of LED, Power, Status and Hard-disk, to indicate
different status of the system.
Allows network administrator to check important system settings such as network
interface, SZ configurations, etc. The navigations buttons from left to right respectively
are "Esc", "Up", "Down", and "Enter".
Connecting the power cord to the built-in open-frame power supply (Input:
100~240 VAC, 50/60 Hz).
Power-On () & Power-Off ( O ).
Don't block the cooling fans. Leave enough open space for ventilation.
5
7
6
15
8
9
Advertisement
Table of Contents
