Manage Ap Lists - LevelOne WHG-311 User Manual

10.3. Manage AP Lists

Manage AP lists; go to: Access Points >> Enter Wide Area AP Management >> List.
When an EAP-200 is discovered or added to the AP list, it can be logically deployed into the WHG Controller's
managed network regardless of its physical location by tunnels.
Initially when an AP has been successfully added to the List, it's "Tunnel Status" will show a red light indicating that
no tunnel is established and that this AP is only being monitored via SNMP.
If you wish to create a tunnel between this AP and the WHG Controller, click the Edit button to proceed with
necessary configurations.
In the AP's tunnel configuration page, check "Enable", set a numerical authentications key between WHG Controller
and AP. Click Apply to create tunnel.
A new window will automatically open and display the tunnel settings on the AP side which is passed from the WHG
Controller. Click the "Reboot" link to apply and activate the settings.
Once the AP has completed the reboot process, the tunnel will be in effect as shown in the APs "Status >>
Overview" page.
154