Feature Access Keys - Mitel SX-200 Manual

SECTION MITL9109-094-108-NA
Page 10
and returns dial tone. The user dials another number. Hanging up at
this point transfers the held party to the dialed number. Pressing the
TRANS/CONF key again when the called party answers reconnects the
held party, forming a conference.
correct internal or external number entered from this set. This key can
be used only if manual dialing has not been initiated.
MESSAGE Key and LED: The MESSAGE LED flashes whenever a mes-
sage is waiting for this set. Pressing this key calls the set that left the
message.
When the SUPERSET
party capable of receiving a message, the MESSAGE LED lights. Press-
ing the MESSAGE Key sends a message to the called set. The LED goes
out and the call is terminated.

Feature Access Keys

4.02 During CDE, some of the set's line appearance keys can be
programmed as feature access keys, eliminating the need for
the user to dial feature access codes. For CDE purposes the keys are
numbered 1 to 12 from bottom to top. These keys cannot be pro-
grammed from the set.
4.03 When a programmed feature is activated its LCD indicator
shows a solid square; (if the feature provides status indication)
otherwise, the LCD indicator is clear. This indicates the on/off status of
the feature, not the validity of using the feature.
4.04 If the Attendant activates a feature on a set's feature access
keys, the corresponding LCD indicator darkens.
4.05 Dialing the access code of a feature available on a feature key
has the same effect as pressing the feature key. If the feature
provides status indication, the corresponding LCD indicator will in-
dicate whether the feature is ON or OFF.
4.06 The CDE-programmable feature keys which do not provide LCD
indication
Call Pickup - the user can answer a call ringing at another telephone in
the set's pickup group without having to dial the pickup code.
Night Answer - the user can answer a call ringing the night bell
without having to dial the night answer access code.
Callback - a busy or unanswered number can be automatically retried
later. If the number was busy, it is called when it becomes idle; if it
was unanswered, it is called when its set becomes idle again after
being used.
3DN telephone reaches a busy or unanswered
include: