Installation; General - Mitel SX-200 Manual

5. INSTALLATION

General

Installation
ANY CONNECTION OF THIS SET TO AN OFF PREMISE APPLICATION,
AN OUT OF PLANT APPLICATION, OR TO ANY OTHER EXPOSED
PLANT APPLICATION MAY RESULT IN A SAFETY HAZARD, AND/OR
DEFECTIVE OPERATION, AND/OR EQUIPMENT DAMAGE.
5.01 Installers should not use a hand test telephone (butt-in) to
check a SUPERSET
status is signaled by data transmission.
5.02 Do NOT connect SUPERSET
parallel, or as Power Fail Transfer extensions.
Note: Before a SUPERSET
the PABX must be programmed and equipped to interface
with a SUPERSET
5.03 Install a SUPERSET
Connect the handset cord to the handset and the main assem-
bly.
l
Identify the user's Prime Line number and other lines appearing
at the SUPERSET
Install the Line Identification Card and protective cover onto the
main assembly.
l
Connect the line cord to the telephone jack.
3 Telephone Description
WARNING
3 telephone line. The interface card for
3 telephones to standard lines, in
3 telephone can be connected to a PABX,
3 telephone.
3 telephone as follows:
3 telephone on the Line Identification Card.
Page 11