Paging; Lockout Alarm; Customer Data Entry/Maintenance - Mitel SX-200 Manual

SECTION MITL9109-094-315-NA
For Hold Pickup Dial: 6605n
q Fl>
Page 18

Paging

The Attendant
3.31
fixed key on the Attendant Console. By using this key the
Attendant can access a default paging zone(s) which has been pro-
grammed in Customer Data Entry (CDE). To access a given paging
zone or all paging zones the Attendant must dial the appropriate
access code. If the Attendant has a call on hold for an extension user,
the hold pickup access code must be given to enable the extension
user to pick up the call. The hold slot access code has three fields as
shown in this example: the feature access code (66), the Attendant
Console number (05) and the hold slot number (1 to 8); refer to Figure
3-25.
q
q
Figure 3-25 Station Hold Slot Access
Lockout Alarm
3.32
(locked out), all consoles will start to warble with a long-
short-long cadence. This cadence overrides all other cadences that
might be active. When a console is warbling with the long-short-long
lockout alarm cadence, the attendant can display the identity of the
locked out device by pressing the FUNCTION hardkey,
TION softkey,
display then shows the time and date the lockout alarm occurred, the
extension number of the device, and a message stating that the device
has been off-hook too long.
Customer Data Entry/Maintenance
3.33 By selecting FUNCTION and the APPLICATION softkey
dant Console may be used as a Customer Data Entry or Main-
tenance Terminal.
and the access level and password. The password may only consist of
numeric characters. If a password has been programmed from the
Maintenance
Data Entry and Maintenance applications will not be accessible from
the Attendant Console. A new, numeric password must be set from the
Maintenance Terminal before these Applications become accessible
from the Attendant Console. At any time during Customer Data Entry
or Maintenance, pressing any hard key will return the Attendant Con-
sole to the call handling mode and display. To resume CDE or Main-
tenance, press:
can access
q
F3>
and the SHOW LOCKOUT softkey,
Application
The display will
Terminal which contains
FUNCTION + APPLICATION
paging equipment using
q
F5>
q ifO>
in this sequence; the
prompt for the application
alphabetic characters,
the PAGE
the APPLICA-
the Atten-
desired,
Customer