Mains Connection For A2 And A3; When Mounting Cables, First Mount And Tighten Earth Cable - Danfoss vlt FC 102 Operating Instructions Manual

®
VLT HVAC Drive Operating Instructions

4.1.5. Mains connection for A2 and A3

Illustration 4.2: First mount the two screws on the mounting plate, slide it into place and tighten fully.
Illustration 4.3: When mounting cables, first mount and tighten earth cable.
The earth connection cable cross section must be at least 10 mm
IEC 61800-5-1
.
MG.11.A6.02 - VLT ® is a registered Danfoss trademark
2 or 2 rated mains wires terminated separately according to
4. Electrical installation
EN 50178/
25
4