Figure 6-10.Add Tcp Or Udp Port Filter - ADC MM702G2-W V5.x User Manual

Step
3 Click Add TCP or UPD Filter
4 Configure the following parameters for each session:
• Source Address – Values are IP Address and Mask. Default is 0.0.0.0.
• Destination Address – Values are IP Address and Mask. Default is 0.0.0.0.
• Protocol – Values are TCP and UDP. Default is TCP.
• Source Port – Values range from 0-65535.
• Destination Port – Values range from 0-65535.
• Direction – Values for Inbound and Outbound are Allow and Block. Default is Allow.
5 Click Apply.
MM702G2-W-UM-03
Action
(Figure 6-9 on page 6-10).
Figure 6-10. Add TCP or UDP Port Filter
Chapter 6: Configuring Advanced Features
Figure 6-10 is displayed.
6-11