ADC MM702G2-W V5.x User Manual page 79

Step
3 Configure the following parameters for each session:
• Session Name
Enter a unique, descriptive identifier for the session. This name can have a maximum of 32
characters.
• Virtual Path ID (VPI)
Enter the value (from 0 to 4,095) provided by the service provider. The number identifies the virtual
path that transports ATM cells between the modem and the service provider. This value must match
the virtual path identification (VPI) value the service provider uses for this connection. Default is 0.
• Virtual Channel ID (VCI)
Enter the value (from 1 to 65,535) provided by the service provider. The number identifies the virtual
channel for this session that transports ATM cells between the modem and the service provider. This
value must match the virtual channel identification (VCI) value the service provider uses for this
connection. Default is 35.
• WAN IP Address
Enter the IP address provided by the service provider for this session. Or if DHCP Client was
selected, the IP address will automatically be assigned by a DHCP server on the WAN side of the
network. Default is 0.0.0.0.
• Enable NAT on this interface
• Encapsulation
Select the encapsulation type as indicated by the service provider. The options are:
– LLC/SNAP—Logical Link Control allows multiple protocols to be run over the session.
– VcMux—Virtual Channel Multiplexer-based encapsulation allows one protocol to be run over the
session. Default is VcMux.
• Authentication
Select the authentication protocol provided by your service provider for PPP sessions. The
authentication protocol type must match at the modem and the service provider. The options are:
– No Authentication—No authentication is required for the session. Default is No Authentication
– PAP—The modem sends authentication requests to the service provider and authentication occurs
only once during the life of the SHDSL link.
– CHAP—The service provider returns an authentication challenge to the modem during the
authentication (default setting).
• User Name
Change the default login name (admin) for this PPP session to the Login name supplied by the
service provider. Minimum login name length is one character and the maximum is 32 characters.
• Password
Change the default login password (password) for this PPP session to the Login password supplied
by the service provider. Minimum password length is six characters and the maximum is 32
characters.
4 Click Configure to add the new PPPoE-Routed session to your session list on the WAN Configuration
page.
MM702G2-W-UM-03
Chapter 5: Configure LAN, WAN, and SHDSL
Action
5-23