Network Settings Menu - Lightware MMX6x2-HT200 User Manual

Enter bootload mode
The firmware of the device can be upgraded in Bootload mode. If the working mode of the
device is not switched to bootload mode automatically, the mode can be also switched
manually.
Step 1. Navigate to Settings / Enter Bootload Mode submenu
Step 2. Press the enter  button to switch to Bootload mode.
Step 3. LCD will display the IP address of the Bootloader. (The
Resetting the device
Step 1. Navigate to Settings / Reset submenu and press the
Step 2. Press the enter  button to restart the device or the
Step 3. The matrix is restarted immediately.

5.4.2. Network Settings menu

DHCP setting
Step 1. Navigate to Network Settings / DHCP submenu and
Step 2. To change the setting, press the enter  button and
Step 3. Press the enter  button to save changes.
Step 4. Press the escape ● button twice to navigate out from
Setting the IP address
Step 1. Navigate to Network Settings / IP Address submenu
Step 2. To change the numbers press the  enter button and
Step 3. Set the numbers by the up ▲ and down ▼ buttons
Step 4. Press the escape ● button twice to navigate out from
Section 5. Installation and operation
and press the enter  button.
device can be switched to normal operation mode by
pressing the reset button or turning the matrix off and
on again.)
enter  button.
escape ● button to cancel.
press the enter  button.
use the up ▲ and down ▼ buttons to toggle between
Enabled and Disabled settings.
the submenu. You will be prompted to apply settings;
press the enter  button.
and press the enter  button.
use the left ◄ and right ► buttons to place the cursor
to the desired number.
and press the enter  button to save changes.
the submenu. You will be prompted to apply settings – press the enter  button.
MMX6x2-HT
User's Manual
¹Settings
½Enter bootloaº
Enter Bootload?
ENTER=Yes ESC=No
BOOTLOADER IP:
192.168.0.95
¹Settings
¼Reset º
Restart Device?
ENTER=Yes ESC=No
¹Network Settin¥
»DHCP º
¹DHCP:
Disabled ½
Apply Settings
ENTER=Yes ESC=No
¹Network Settin¥
½IP Address º
¹IP Address:
192.168.002.2½
Apply Settings
ENTER=Yes ESC=No
Page 39 / 119