3
Mechanical installation
Before installing or removing an option module from any drive, ensure the AC supply
has been disconnected for at least 10 minutes and refer to Chapter 1 Safety
information on page 5. If using a DC bus supply ensure this is fully discharged before
working on any drive or option module.
WARNING
3.1
General Installation
The installation of an option module is illustrated in Figure 3-1.
Figure 3-1 Option module installation
3.1.1
Installing the first option module
Option module slots must be used in the following order: slot 3, slot 2 and slot 1.
•
Align the option module above the drive as shown
•
Insert the option module tab into the slot on the drive
•
Press down on the option module until it clicks into place
MCi210 User Guide
Issue Number: 2
9