Emerson MCi210 User Manual page 28

S.02.008
Minimum
Default
Type
Display Format
Coding
This parameter controls and displays the default gateway of the module.
If DHCP is enabled (DHCP Enable (S.02.005)) this parameter becomes read-only and, until an IP
Address is allocated to the module, will display 0.0.0.0.
If DHCP is disabled the module will initialize, on reset or power cycle, with the default gateway
stored for the parameter.
S.02.009
Minimum
Default
Type
Display Format
Coding
The module can use this IP Address when it wishes to resolve the IP Address for a domain name.
This parameter performs the same function as the Secondary DNS parameter (Secondary DNS
(S.02.010)), however the address specified in this parameter will be tried first. Only when this
address is unsuccessful will the Secondary DNS address be tried.
If DHCP is enabled (DHCP Enable (S.02.005)) this parameter becomes read-only and, until an IP
Address is allocated to the module, will display 0.0.0.0.
If DHCP is disabled the module will initialize, on reset or power cycle, with the primary DNS
address stored for the parameter.
28
Default Gateway
0 (Display: 0.0.0.0)
3232236030
(Display: 192.168.1.254)
32 Bit User Save
IP Address
RW, BU
Primary DNS
0 (Display: 0.0.0.0)
0 (Display: 0.0.0.0)
32 Bit User Save
IP Address
RW, BU
4294967295
Maximum
(Display: 255.255.255.255)
Units
DHCP enabled: write on
event;
Update Rate
DHCP disabled: read on
reset
Decimal Places 0
4294967295
Maximum
(Display:255.255.255.255)
Units
DHCP enabled: write on
event;
Update Rate
DHCP disabled: read on
reset
Decimal Places 0
MCi210 User Guide
Issue Number: 2