Emerson MCi210 User Manual page 29

S.02.010
Minimum
Default
Type
Display Format
Coding
The module can use this IP Address when it wishes to resolve the IP Address for a domain name.
This parameter performs the same function as the Primary DNS parameter (Primary DNS
(S.02.009)), however the address specified in this parameter will be tried only when the Primary
DNS address is unsuccessful.
If DHCP is enabled (DHCP Enable (S.02.005)) this parameter becomes read-only and, until a
secondary DNS address is allocated to the module, will display 0.0.0.0.
If DHCP is disabled the module will initialize, on reset or power cycle, with the secondary DNS
address stored for the parameter.
S.02.011
Minimum
Default
Type
Display Format
Coding
This parameter shows the 48-bit MAC address of the module.
S.02.020
Minimum
Default
Type
Display Format
Coding
This parameter enables the selection of the fieldbus protocol to have priority over all other
protocols. A tick period of 1 ms will be given to the highest priority fieldbus protocol, 5 ms to all
other fieldbus protocols (equal priority).
If no fieldbus protocol has been selected to have priority over others, all protocols will have equal
priority and a tick rate of 5 ms.
MCi210 User Guide
Issue Number: 2
Secondary DNS
0 (Display: 0.0.0.0)
0 (Display: 0.0.0.0)
32 Bit User Save
IP Address
RW, BU
MAC Address
0 (Display:
00:00:00:00:00:00)
64 Bit Volatile
Mac Address
RO, ND, NC, PT, BU
Priority Protocol
0
0
8 Bit User Save
None
RW, Txt, BU
Maximum
Units
Update Rate
Decimal Places
281474976710655
Maximum
(Display: FF:FF:FF:FF:FF:FF)
Units
Update Rate Power-up write
Decimal Places 0
Maximum
Units
Update Rate
Decimal Places
4294967295
(Display: 255.255.255.255)
DHCP enabled: write on
event;
DHCP disabled: read on
reset
0
2
Background read
0
29