Emerson MCi210 User Manual page 27

When DHCP is enabled, the following parameters will become read-only immediately (no reset
required):
IP Address (S.02.006)
Subnet Mask (S.02.007)
Default Gateway (S.02.008)
Primary DNS (S.02.009)
Secondary DNS (S.02.010)
S.02.006
Minimum
Default
Type
Display Format
Coding
This parameter controls and displays the IP Address of the module.
If DHCP is enabled (DHCP Enable (S.02.005)) this parameter becomes read-only and, until an IP
Address is allocated to the module, will display 0.0.0.0.
If DHCP is disabled the module will initialize, on reset or power cycle, with the IP Address stored for
the parameter.
S.02.007
Minimum
Default
Type
Display Format
Coding
This parameter controls and displays the subnet mask of the module.
If DHCP is enabled (DHCP Enable (S.02.005)) this parameter becomes read-only and, until an IP
Address is allocated to the module, will display 0.0.0.0.
If DHCP is disabled the module will initialize, on reset or power cycle, with the subnet mask stored
for the parameter.
MCi210 User Guide
Issue Number: 2
IP Address
0 (Display: 0.0.0.0)
3232235876
(Display: 192.168.1.100)
32 Bit User Save
IP Address
RW, BU
Subnet Mask
0 (Display: 0.0.0.0)
4294967040
(Display: 255.255.255.0)
32 Bit User Save
IP Address
RW, BU
4294967295
Maximum
(Display: 255.255.255.255)
Units
DHCP enabled : write on
Update Rate event; DHCP disabled :
read on reset
Decimal Places 0
4294967295
Maximum
(Display:255.255.255.255)
Units
DHCP enabled : write on
Update Rate event; DHCP disabled :
read on reset
Decimal Places 0
27