Emerson MCi210 User Manual page 44

S.10.001
Minimum
Default
Type
Display Format
Coding
This parameter is used to enable the easy mode cyclic Data. If set to zero, the transmit and receive
cyclic links will be disabled even if all the setup parameter are correctly configured.
S.10.002
Minimum
Default
Type
Display Format
Coding
This parameter is used to perform a warm reset of the easy mode cyclic data interface. This
parameter will be automatically set to Off (0) when the reset has been completed.
This parameter must be set after any changes are made to the parameters in menu 10 to ensure
that the changes take effect.
Setting this parameter will only effect menu 10 and does not affect the other menus or protocols
supported by the module.
S.10.003
Minimum
Default
Type
Display Format
Coding
This parameter allows all parameters in menu 10 to be defaulted to factory settings.
To default the parameters in menu 10, set this parameter to On (1) and then reset the menu by
setting Reset (S.10.002) to On (1), or reset the module by setting Reset Module (S.00.007) to On
(1). This parameter will be automatically set to Off (0) when the default operation has been
completed.
44
Enable
0
1
1 Bit User Save
None
RW, BU
Reset
0
0
1 Bit Volatile
None
RW
Default
0
0
1 Bit Volatile
None
RW
Maximum
Units
Update Rate
Decimal Places
Maximum
Units
Update Rate
Decimal Places
Maximum
Units
Update Rate
Decimal Places
1
Background read
0
1
Background read
0
1
Read on reset
0
MCi210 User Guide
Issue Number: 2