Genie Z80/60 Service Manual page 214

Section 4 • Repair Procedures
AXLE COMPONENTS
How to Adjust a Steer Sensor
1 Start the engine from the platform controls.
2 Press down the foot switch and push the engine
idle select button until the engine switches to
high rpm.
Square-end steer sensors:
3 At the platform controls, press the circle-end
steer mode button.
4 Locate the steer sensor on top of the yoke pivot
pin.
5 Loosen the steer sensor cover retaining
fasteners. Do not remove them.
6 Rotate the steer sensor cover either clockwise
or counterclockwise. Measure the distance
between the inside of tire and the chassis side
plate on both sides of the axle.
7 Repeat step 4 until the tire is parallel with the
chassis.
8 Tighten the steer sensor cover fasteners.
9 Repeat steps 2 through 6 for the other square-
end steer sensor.
4 - 112
Circle-end steer sensors:
10 At the platform controls, press the square-end
steer mode button.
11 Locate the steer sensor on top of the yoke pivot
pin.
12 Loosen the steer sensor cover retaining
fasteners. Do not remove them.
13 Rotate the steer sensor cover either clockwise
or counterclockwise. Measure the distance
between the inside of tire and the chassis side
plate on both sides of the axle.
14 Repeat step 4 until the tire is parallel with the
chassis.
15 Tighten the steer sensor cover fasteners.
16 Repeat steps 9 through 13 for the other circle-
end steer sensor.
17 At the platform controls, press the four-wheel
steer mode button. Measure the distance
between the inside of the tire and the chassis
side plate on both sides of the axle on each tire.
18 If any tire is not parallel, repeat the process
beginning with step 3.
Z-80/60
June 2011
REV B
Part No. 88619