Perform 30 Day Service; Perform Engine Maintenance - Continental Models - Genie Z80/60 Service Manual

June 2011
REV E
A-6

Perform 30 Day Service

The 30 day maintenance procedure is a one time
sequence of procedures to be performed after the
first 30 days or 40 hours of usage. After this
interval, refer to the maintenance checklists for
continued scheduled maintenance.
1 Perform the following maintenance procedures:
· A-10 Grease the Turntable Rotation
Bearing and Rotate Gear
· B-7 Check the Tires, Wheels and
Lug Nut Torque
· B-9 Check the Drive Hub Oil Level and
Fastener Torque
· D-3 Check the Turntable Rotation
Bearing Bolts
· D-7 Replace the Hydraulic
Filter Elements
Part No. 88619
Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
A-7
Perform Engine Maintenance -
Continental Models
Engine specifications require that this one-time
procedure be performed after the first 50 hours.
Required maintenance procedures and additional
engine information are available in the
Continental TME27 Owner's Manual
(Continental part number WM10303).
Continental TME27 Owner's Manual
Genie part number
To access the engine:
1 Remove the engine tray retaining fastener
located under the engine tray. Swing the engine
tray out and away from the machine.
2 Install the fastener that was just removed
through the engine tray and into the engine tray
anchor hole in the turntable.
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
Z-80/60
111901
3 - 11