Genie Z80/60 Service Manual page 117

1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2
June 2011 July 2013
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2
REV F REV E
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2
8 Move the boom/turntable rotate joystick full
stroke in the down direction and hold for 5
seconds, then return to the center or neutral
position.
Result: The alarm at the ground controls should
sound for a successful calibration.
Result: If the alarm does not sound, repeat
calibration procedure.
Turntable rotate functions:
1 Turn the key switch to the off position.
2 Press and hold the enter button
ground control panel while turning the key
switch to platform controls.
3 Press the minus button
enter button twice.
4 Use the scroll button
menu until
RESET TURNTABLE ROTATE LEFT
is displayed. Press the
JOYSTICK DEFAULTS
button to select , then press the
YES
5 Do not start the engine.
6 Locate the primary boom/turntable rotate
joystick.
7 Move the boom/turntable joystick full stroke in
the left direction and hold for 5 seconds, then
return to the center or neutral position.
8 Move the boom/turntable joystick full stroke in
the right direction and hold for 5 seconds, then
return to the center or neutral position.
Result: The alarm at the ground controls should
sound for a successful calibration.
Result: If the alarm does not sound, repeat
calibration procedure.
Part No. 88619
on the
twice, then press the
to scroll through the
/
RIGHT
button.
Z-80/60
Section 4 • Repair Procedures
How to Reset a Proportional
Valve Coil Default
Note: This procedure only needs to be performed if
a proportional valve has been replaced.
Note: After the valve coil defaults have been set,
each machine function threshold and default
function speed must be set. See How to Set the
Function Thresholds and Default Function Speeds.
1 Turn the key switch to the off position.
2 Press and hold the enter button
ground control panel while turning the key
switch to platform controls.
3 Press the minus button
enter button twice.
4 Use the scroll button
menu until the function valve that needs to be
reset is displayed. Press the
, then press the
YES
PLATFORM CONTROLS
on the
twice, then press the
to scroll through the
button to select
button.
4 - 15