Genie Z80/60 Service Manual page 91

June 2012
REV E
4 Fill the hub with oil from the top hole until the oil
level is even with the bottom of the side hole.
Apply pipe thread sealant to the plugs. Install
the plugs.
5 Models with pipe plugs: Apply pipe thread
sealant to the plugs and install the plugs.
Models with O-ring plugs: Install the plugs
into the drive hub.
6 Repeat steps 1 through 5 for the other drive
hub.
Turntable Rotate Drive Hub:
1 Secure the turntable from rotating with the
turntable rotation lock pin.
unlocked
2 Remove the motor/brake mounting bolts, and
then remove the motor and brake from the drive
hub and set them to the side.
Component damage hazard.
Hoses can be damaged if they are
kinked or pinched.
Part No. 88619
3 Remove the drive hub mounting bolts, and use
4 Remove the plug from the side of the drive hub.
locked
5 Install the drive hub. Torque the drive hub
6 Install the brake and motor onto the drive hub.
7 Fill the hub with oil from the side hole until the
8 Adjust turntable rotation gear backlash. Refer to
Z-80/60
Section 3 • Scheduled Maintenance Procedures
CHECKLIST D PROCEDURES
a motor
b motor/brake mounting bolts
c brake
a lifting device to remove the drive hub from the
machine.
Drain the oil from the hub into a container of
adequate capacity. Refer to Section 2,
Specifications.
mounting bolts to specification. Refer to
Section 2, Specifications.
Torque the motor/brake mounting bolts to
specification. Refer to Section 2, Specifications.
oil level is even with the bottom of the hole.
Apply pipe thread sealant to the plug. Install the
plug.
Repair Procedure 9-1, How to Adjust the
Turntable Rotation Gear Backlash.
3 - 57