Genie Z80/60 Service Manual page 82

Section 3 • Scheduled Maintenance Procedures
CHECKLIST C PROCEDURES
Perkins 804C-33 or 804D-33 Models:
2 Remove the engine tray retaining fastener
located under the engine tray. Swing the engine
tray out and away from the machine.
3 Install the fastener that was just removed
through the engine tray and into the engine tray
anchor hole in the turntable.
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
All Models:
4 Release the clamps from the end cap of the air
filter canister. Remove the end cap.
5 Remove the filter element.
6 Clean the inside of the canister and the gasket
with a damp cloth.
7 Install the new filter element.
8 Install the air filter canister end cap and connect
the end cap retaining clamp.
3 - 48
C-5
Replace the Fuel/Water
Separator - Diesel Models
Genie specifications require that this procedure be
performed every 500 hours or annually, whichever
comes first.
Regular replacement of the fuel filter/water
separator is essential for good engine
performance. Failure to perform this procedure can
lead to poor engine performance and/or hard
starting, and continued use may result in
component damage. Extremely dirty conditions
may require this procedure be performed more
often.
Explosion and fire hazard. Engine
fuels are combustible. Perform this
procedure in an open, well-
ventilated area away from heaters,
sparks, flames and lighted
tobacco. Always have an
approved fire extinguisher within
easy reach.
Note: Perform this procedure with the engine off.
1 Open the engine side turntable cover and locate
the fuel filter/water separator.
Note: The fuel filter/water separator is located near
the hydraulic pump.
Z-80/60
June 2011
REV E
Part No. 88619