HP A6600 Configuration Manual page 75

Configuration procedure
Configure the RADIUS server.
1.
# Add an access device.
Log in to the iMC management platform, click the Service tab, and select User Access Manager > Access
Device from the navigation tree to enter the Access Device page. Then, click Add to enter the Add Access
Device page, and perform the following configurations as shown in
Set the shared key for authentication and accounting to expert.
a.
Specify the ports for authentication and accounting as 1812 and 1813, respectively.
b.
Select LAN Access Service as the service type.
c.
Select HP as the access device type.
d.
Select the access device from the device list, or manually add the device whose IP address is
e.
10.1.1.2.
Adopt the default settings for other parameters, and click OK to finish the operation.
f.
NOTE:
The IP address of the access device specified above must be the same as the source IP address of the
RADIUS packets sent from the device, which is the IP address of the outbound interface (the default), or
the IP address specified with nas-ip or radius nas-ip.
Figure 19 Add an access device
Figure
63
19: