HP A6600 Configuration Manual page 152

Configure IP addresses for the host, router, and servers as shown in
can reach each other.
Perform configurations on the RADIUS server to ensure that the user authentication and accounting
functions can work normally.
The following example describes how to configure the portal server on the iMC. iMC PLAT 5.0(E0101)
and iMC UAM 5.0(E0101) are used in this example.
Configuration procedure
Configure the portal server.
1.
# Configure the portal server.
Log on to the iMC management platform and click the Service tab. Then, select User Access Manager >
Portal Service Management > Server from the navigation tree to enter the portal server configuration
page, as shown in
Configure the portal parameters as needed. This example uses the default values.
•
Figure 52 Portal server configuration
# Configure the IP address group.
Select User Access Manager > Portal Service Management > IP Group from the navigation tree to enter
the portal IP address group configuration page. Then, click Add to enter the page for adding an IP
address group, as shown in
Enter the IP group name.
a.
Enter the start IP address and end IP address of the IP group. Make sure that the IP address of
b.
the user host (2.2.2.2) is in the IP group.
Select a service group. By default, Ungrouped is used.
c.
Select the IP group type as Normal.
d.
Figure 52.
Figure 53.
140
Figure 51 and make sure that they