HP A6600 Configuration Manual page 44

To configure a router to interpret the RADIUS class attribute as CAR parameters:
To do...
1. Enter system view.
2. Enter RADIUS scheme view.
3. Interpret the class attribute as
CAR parameters.
Enabling the trap function for RADIUS
With the trap function, a NAS sends a trap message when either of the following events occurs:
The status of a RADIUS server changes. If a NAS receives no response to an accounting or
•
authentication request before the specified maximum number of RADIUS request transmission
attempts is exceeded, it considers the server unreachable, sets the status of the server to block, and
sends a trap message. If the NAS receives a response from a RADIUS server that it considers
unreachable, the NAS considers that the RADIUS server is reachable again, sets the status of the
server to active, and sends a trap message.
The ratio of the number of failed transmission attempts to the total number of authentication request
•
transmission attempts reaches the threshold. This threshold ranges from 1% to 100% and defaults to
30%. This threshold can only be configured through the MIB.
The failure ratio is generally small. If a trap message is triggered because the failure ratio is higher than
the threshold, troubleshoot the configuration on and the communication between the NAS and the
RADIUS server.
To enable the trap function for RADIUS:
To do...
1. Enter system view.
2. Enable the trap
function for RADIUS.
Enabling the RADIUS listening port of the RADIUS client
After you enable the RADIUS listening port of a RADIUS client, the client can receive and send RADIUS
packets. If RADIUS is not required, disable the RADIUS listening port to avoid attacks that exploit
RADIUS packets.
To enable the RADIUS listening port of a RADIUS client:
To do...
1. Enter system view.
2. Enable the RADIUS listening
port of a RADIUS client.
Command...
system-view
radius scheme radius-
scheme-name
attribute 25 car
Command...
system-view
radius trap { accounting-server-down |
authentication-error-threshold | authentication-
server-down }
Command...
system-view
radius client enable
32
Remarks
—
—
Required.
Be default, RADIUS attribute 25 is not
interpreted as CAR parameters.
Remarks
—
Required
Disabled by default
Remarks
—
Optional
Enabled by default