HP A6600 Configuration Manual page 63

Figure 10 Configure authentication/authorization for Telnet users through a RADIUS server
Telnet user
192.168.1.58/24
Configuration procedure
This example assumes that the RADIUS server runs iMC PLAT 5.0 (E0101) and iMC UAM 5.0 (E0101).
Configure the RADIUS server.
1.
# Add an access device.
Log in to the iMC management platform, click the Service tab, and select User Service Manager > Access
Device from the navigation tree to enter the Access Device page. Then, click Add to enter the Add Access
Device page, and perform the following configurations as shown in
Set the shared key for authenticating authentication and accounting to expert.
a.
Specify the ports for authentication and accounting as 1812 and 1813, respectively.
b.
Select Device Management Service as the service type.
c.
Select HP as the access device type.
d.
Select the access device from the device list, or manually add the device with the IP address of
e.
10.1.1.2.
Click OK to finish the operation.
f.
NOTE:
The IP address of the access device specified above must be the same as the source IP address of the
RADIUS packets sent from the device, which is the IP address of the outbound interface for RADIUS
packets (the default), or the IP address specified with nas-ip or radius nas-ip.
RADIUS server
10.1.1.1/24
GE1/0/2
10.1.1.2/24
GE1/0/1
192.168.1.70/24
Router
Internet
Figure
51
11: