HP A6600 Configuration Manual page 294

Verification
After the configuration, Router A, Router B, and Router C learn IPv6 routing information through RIPng.
SAs are set up successfully, and the IPsec tunnel between two peers is up for protecting the RIPng
packets.
Using display ripng on Router A, you see the running status and configuration information of the
specified RIPng process. The output shows that IPsec policy policy001 is applied to this process
successfully.
<RouterA> display ripng 1
RIPng process : 1
Preference : 100
Checkzero : Enabled
Default Cost : 0
Maximum number of balanced paths : 8
Update time
Suppress time :
Number of periodic updates sent : 186
Number of trigger updates sent : 1
IPsec policy name: policy001, SPI: 12345
Using display ipsec sa on Router A, you see information about the inbound and outbound SAs.
<RouterA> display ipsec sa
===============================
Protocol: RIPng
===============================
-----------------------------
IPsec policy name: "policy001"
sequence number: 10
mode: manual
-----------------------------
connection id: 1
encapsulation mode: transport
perfect forward secrecy:
tunnel:
flow:
[inbound ESP SAs]
spi: 12345 (0x3039)
proposal: ESP-ENCRYPT-DES ESP-AUTH-SHA1
No duration limit for this sa
[outbound ESP SAs]
spi: 12345 (0x3039)
proposal: ESP-ENCRYPT-DES ESP-AUTH-SHA1
No duration limit for this sa
Similarly, view the information on Router B and Router C. (Omitted)
: 30 sec(s) Timeout time
120 sec(s) Garbage-Collect time :
282
: 180 sec(s)
120 sec(s)