HP A6600 Configuration Manual page 47

To do...
4. Specify the secondary HWTACACS
authentication server.
NOTE:
An HWTACACS server can function as the primary authentication server of one scheme and as the
•
secondary authentication server of another scheme at the same time.
The IP addresses of the primary and secondary authentication servers cannot be the same.
•
Otherwise, the configuration fails.
Remove an authentication server only when no active TCP connection for sending authentication
•
packets is using it.
Specifying the HWTACACS authorization servers
Specify one primary authorization server and up to one secondary authorization server for an
HWTACACS scheme so that the NAS can find a server for user authorization when using the scheme.
When the primary server is not available, the secondary server (if any) is used. In a scenario where
redundancy is not required, specify only the primary server.
To specify HWTACACS authorization servers for an HWTACACS scheme:
To do...
1. Enter system view.
2. Enter HWTACACS scheme view.
3. Specify the primary HWTACACS
authorization server.
4. Specify the secondary
HWTACACS authorization server.
NOTE:
An HWTACACS server can function as the primary authorization server of one scheme and as the
•
secondary authorization server of another scheme at the same time.
The IP addresses of the primary and secondary authorization servers cannot be the same.
•
Otherwise, the configuration fails.
Remove an authorization server only when no active TCP connection for sending authorization
•
packets is using it.
Specifying the HWTACACS accounting servers and the relevant parameters
Specify one primary accounting server and up to one secondary accounting server for an HWTACACS
scheme so that the NAS can find a server for user accounting when using the scheme. When the
primary server is not available, the secondary server (if any) is used. In a scenario where redundancy is
not required, specify only the primary server.
Command...
secondary authentication ip-
address [ port-number | vpn-
instance vpn-instance-name ] *
Command...
system-view
hwtacacs scheme hwtacacs-
scheme-name
primary authorization ip-
address [ port-number | vpn-
instance vpn-instance- name ]
*
secondary authorization ip-
address [ port-number | vpn-
instance vpn-instance- name ]
*
35
Remarks
command.
No authentication server is
specified by default.
Remarks
—
—
Required.
Configure at least one command.
No authorization server is
specified by default.