HP A6600 Configuration Manual page 350

++++++++++++++
+++++
++++++++
# Generate a DSA key pair.
[Router] public-key local create dsa
The range of public key size is (512 ~ 2048).
NOTES: If the key modulus is greater than 512,
It will take a few minutes.
Press CTRL+C to abort.
Input the bits of the modulus[default = 1024]:
Generating Keys...
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+++++++++++++++++++++++++++++++++++
# Enable the SSH server.
[Router] ssh server enable
# Enable the SFTP server.
[Router] sftp server enable
# Configure an IP address for interface GigabitEthernet 1/0/1, which the client uses as the destination
for SSH connection.
[Router] interface GigabitEthernet 1/0/1
[Router-GigabitEthernet1/0/1] ip address 192.168.1.45 255.255.255.0
[Router-GigabitEthernet1/0/1] quit
# Set the authentication mode of the user interfaces to AAA.
[Router] user-interface vty 0 4
[Router-ui-vty0-4] authentication-mode scheme
# Enable the user interfaces to support SSH.
[Router-ui-vty0-4] protocol inbound ssh
[Router-ui-vty0-4] quit
# Configure a local user named client002 with the password being aabbcc and the service type being
SSH.
[Router] local-user client002
[Router-luser-client002] password simple aabbcc
[Router-luser-client002] service-type ssh
[Router-luser-client002] quit
# Configure the user authentication method as password and service type as SFTP.
[Router] ssh user client002 service-type sftp authentication-type password
Establish a connection between the SFTP client and the SFTP server.
2.
NOTE:
The router supports a variety of SSH client software. The following takes the PSFTP of PuTTY Version
•
0.58 as an example.
The PSFTP supports only password authentication.
•
338