Table of Contents
Advertisement
Configuring the printer
CAUTION
Be extremely careful changing any of the printer
settings to the avoid possibility of changing other
settings that might affect the performance of the
printer.
1.
Open the receipt cover and check if there is paper in
the printer. If not, follow the instructions for loading
paper.
2.
Turn the printer so the back is facing you.
3.
Open the receipt cover and press the reset button
while holding the paper feed button. Use the eraser
end of pencil to press reset button.
•
The printer beeps, prints the diagnostic form
and the configuration main menu.
•
The printer pauses and waits for a main menu
selection to be made (see sample printout
below.)
: A776-0000-0000
: 0000000000
: PN#: 189-776L116
: Jul 6 2016
: V1.42
: C0F4
: 189-776A142A
: 8 Mbytes
: 1600 kbytes
: 576 kbytes
: 2240 kbytes
: 640 kbytes
: 512 kbytes
: H
: 1
: Type 0, Monochrome
: n/a
: 100%
: 300 mm/sec
: 80 mm
: Level 1
: Enabled
: 135 steps
: Enabled
A776 2UG0001 B 11/2016
: USB
5.
6.
7.
- Set Firmware Features
A776II Two-Color Thermal/Impact Hybrid Printer: User Guide
Chapter 3: Settng up the Printer
Follow the printed instructions on the scrolling
menu by pressing the paper feed button as
indicated below to make selections.
•
Indicate Yes with a long click. Press and hold
paper feed button for more than one second.)
•
Indicate No with a short click. Press paper
feed button quickly.
Continue through your menu selections until you
are asked, "Save New Parameters?" Select "Yes" or
"No. "
a.
If you wish to save, select "Yes".
b.
Press the reset button. The printer resets with
the new selections. You can verify the setting
by pressing the paper feed button to print out
a diagnostics form or by holding the paper
feed button and opening and closing the
receipt cover.
If you would like to continue configuring the printer,
select "No". The printer returns to the configuration
menu where you can set parameters again.
- > 8 clicks
17
Advertisement
Table of Contents
