Configuring the printer
The configuration menu allows you to select functions or
change various settings for the printer. Instructions printed
on the receipt, guide you through the processes.
Note: When changing the paper type, you will need to
either send the "Set paper type" (1D 81 m n) command or
use the "Set Paper Type" selection from the configuration
menu.
See paper types available on page 48.
Caution: Be extremely careful changing any of the printer
settings to avoid inadvertently changing other settings that
might affect the performance of the printer.
1 Open the receipt cover and check if there is paper in
the printer. If not, follow the instructions on page 18 for
loading paper.
2 Turn the printer so the back is facing you.
�����������������
������������������
��
���
� �
�����������������������
���������������
3 Set DIP switch 1 to the On position (up).
4 Open the front cover of the printer and press the reset
button while holding the paper feed button.
�����
�����
189-9200303 Rev. E
����������
������
�����
������
12/2012
Chapter 4: Using the Printer
• The printer beeps, prints the diagnostic form and the
configuration main menu.
• The printer pauses and waits for a main menu
selection to be made (see sample printout below.)
����
��������������������������
��������������������������������������������������
����������
���������������������������������������������������
���������������������
������������������������������������������������
�������������
��������������������������������������������������
����������������������
����������
���������������������������������������������
��������������������������������
�����������������������������������������������
����������������������������������
����������������
���������
��������
�
��������������������������
�������������������
������
�����������������������������
�����������������������������
�����������������������
�������������������������������� �� ��������
����������������������
����������������
���������������������������������
�����������������������������
5 Follow the printed instructions on the scrolling menu
by pressing the paper feed button as indicated below to
make selections.
• Indicate Yes with a long click. (Press and hold paper
feed button for more than one second.)
• Indicate No with a short click. (Press paper feed
button quickly.).
6 Continue through your menu selections until you are
asked, "Save New Parameters?" Select "Yes" or "No".
a If you wish to save, select "Yes", then return DIP
switch 1 to the Off position (down).
b Press the reset button. The printer resets with
the new selections. You can verify the setting
by pressing the paper feed button to print out a
diagnostics form or by holding the paper feed button
and opening and closing the receipt cover.
7 If you would like to continue configuring the printer,
select "No". The printer returns to the configuration
menu where you can set parameters again.
A760 Two-Color Thermal/Impact Hybrid Printer: User Guide
29
����
��������
�
�� �������
�� ��������
�� ��������
�� ��������
�� ��������
�� ��������