Anritsu MS2024A/MS2026A User Manual page 71

Chapter 3 — Vector Network Analyzer 3-6 VNA Measurements - Distance-To-Fault (DTF)/Fault Location
5. Press the
Back
sure that Stop Distance is smaller than Dmax.
6. Press the
Shift
7. Press the
Start Cal
end of the extension cable. Follow the instructions on the display or refer to
for more details.
8. When the Calibration is finished,
of the display and the trace should be 0 dB when the short or open is connected.
9. Press the
Marker
Figure 3-10. DTF Measurement With a Short at the End of Cable
MS20xxA VNA Master UG 10580-00166 Rev. C
soft key and use the
key, then the
Calibrate
soft key and perform a 1-port OSL calibration at the connector or at
Cal Status On
function hard key and select the
soft key to enter the Stop Distance. Make
Stop Dist
(2) key.
should be displayed in the upper left part
Peak Search
Chapter 3
soft key.
3-17